Porsche GT3 belts are designed specifically for street cars with Porsche’s factory One Piece Carbon Buckets.
What makes GT3 belts different? The lap belts use specific sewn-in brackets that fit perfectly on the factory mount on the Porsche carbon buckets. A standard belt would require additional fabrication and a spacer to make them work with the factory seats. These are a bolt-in replacement which is much easier.
Available with Pull-Down lap belts and No Adjust subs only. Shoulders are 3"
If you drive a GT3 Cup car or are driving a Porsche with a fixed back race seat, a standard non Porsche specific harness such as the Enduro 2x2 or Flexi 2x2 would be better suited for your vehicle.
-
Components
- Shoulders: Pull Down 3"
- Laps: Pull Down 2"
- Subs: No Adjust 2"
End Fittings
- Shoulder: LV7 Wrap (3" Shoulders)
- Lap: Sewn-in B43A (GT3 Specific Hardware)
- Subs: LV10 with B14 Snap-in Bracket Wrapped-in
Included Hardware
- (1) SG23 eyebolt and (2) S3 wavy washers for substrap installation
- (2) B24 bolt in brackets, (2) LV4 2 bar slides, (2) 7/16 pivot sleeves, and (2) 7/16 flat washers for optional bolt in substrap installation
- (2) SG10 bolts, (2) SG29 bolts, (2) wavy washers, (2) 7/16 pivot sleeves, (2) 7/16 flat washers, (4) spacers for a number of different lap belt installations
Homologation
- FIA 8853-2016
-
Specifications
Components
- Shoulders: Pull Down 3"
- Laps: Pull Down 2"
- Subs: No Adjust 2"
End Fittings
- Shoulder: LV7 Wrap (3" Shoulders)
- Lap: Sewn-in B43A (GT3 Specific Hardware)
- Subs: LV10 with B14 Snap-in Bracket Wrapped-in
Included Hardware
- (1) SG23 eyebolt and (2) S3 wavy washers for substrap installation
- (2) B24 bolt in brackets, (2) LV4 2 bar slides, (2) 7/16 pivot sleeves, and (2) 7/16 flat washers for optional bolt in substrap installation
- (2) SG10 bolts, (2) SG29 bolts, (2) wavy washers, (2) 7/16 pivot sleeves, (2) 7/16 flat washers, (4) spacers for a number of different lap belt installations
Homologation
- FIA 8853-2016
- Documents / Spec Sheets
